EPOX Pentium 4 Processor based AGP 4X mainboard Manual de usuario descargar pdf (Pagina 67)

- 62 -

SuperIO Device

Option are in its sub-menu.

Press<Enter>to enter the sub-menu of detailed options.

Onboard FDC Controller

This item specifices onboard floppy disk drive controller. This setting

allows you to connect your floppy disk drives to the onboard floppy

connector.

Ø The choice: Enabled or Disabled.

Onboard Serial Port1

This option is used to assign the I/O address and interrupt request ( IRQ

) for the onboard serial port1 ( COM1 ).

Ø The choice: Disabled, 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3

or Auto.

Onboard Infrared Port

This option is used to assign the I/O address and interrupt request ( IRQ

) for the onboard infrared port.

Ø The choice: Disabled, 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3

or Auto.

UART Mode Select

This field is available if the Onboard Serial Port 2 field is set to any option

but disabled. UART Mode Select enables you to select the infrared com-

munication protocol-Normal ( default ), IrDA, or ASKIR. IrDA is an infra-

red communication protocol with a maximum baud rate up to 115.2K

bps. ASKIR is Sharp's infrared communication protocol with a maximum

baud rate up to 57.6K bps.

Ø The choice: SCR, IrDA or ASKIR .

UR2 Duplex Mode

This item is available when UART 2 mode is set to either ASKIR or

IrDA. This item enables you to determin the infrared function of the

onboard infrared chip. The options are Full and Half ( default ).

Full-duplex means that you can transmit and send information simulta-

neously. Half-duplex is the transmission of data in both directions, but

only one direction at a time.

Ø The choice: Full or Half.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 80 81

Sin comentarios

EPOX Pentium 4 Processor based AGP 4X mainboard Manual de usuario Pagina 67